About Crib Safety
Here you will find tips on choosing and maintaining a crib, along with recommended practices for safe bedding, price comparisons and more.
More infants die every year in accidents involving cribs than with any other nursery product. Thousands of infants are injured seriously enough to require treatment in hospital emergency rooms.
If You Buy A Full Sized Crib
- Corner posts should not extend more than 1/16 inch (1 1/2 mm) above the top of the end panel. Corner posts can be catchpoints for items placed around a child's neck or clothing worn by the child.
- Mattress support hangers should be secured by bolts or closed hooks. All crib hardware should be securely tightened and checked frequently.
- Bumper pads, if used, should (a) fit around the entire crib, (b) tie or snap into place, and (c) have straps or ties at least in each corner, in the middle of each long side, and on both the top and the bottom edges. To prevent your baby from becoming entangled in the ties, trim off excess length after tying. Use the bumpers until the baby can pull up to a standing position, then remove them so that the baby will not use them to try to climb out of the crib.
- Remove and destroy all plastic wrapping materials. Never use plastic bags as mattress covers. The plastic film may cling to a baby's face and cause suffocation.
For People Who Already Own A Crib
- CPSC discourages the use of a used crib. Use cribs that meets Federal safety regulations and industry voluntary standards (ASTM) and make sure it has a tight fitting mattress. Check the labeling on these products to make sure they meet safety requirements.
- Check the crib and replace any missing parts, such as screws, bolts or mattress support hangers, before placing your child in it. Make sure all screws or bolts are securely tightened. Any screw inserted into a wood component that cannot be tightened securely should be replaced by one that fits. On baby beds where the mattress support is suspended by hangers attached to hooks on the end panels, check frequently to be sure they have not become disconnected. Never use a crib with broken or missing parts.
- Use a mattress that fits tightly. If you can fit more than two fingers between the edge of the mattress and crib side, the mattress is too small. An infant can suffocate if its head or body becomes wedged between the mattress and the sides.
- Avoid older baby beds with headboard and footboard designs that may allow an infant's head to become caught in the openings between the corner post and the top rail, or in other openings in the top edge of the headboard structure. These openings may lead to strangulation.
- Corner posts should be less than 1/16 inches high. (1-1/2 mm) unless there is a canopy. Do not use a crib that has decorative knobs on corner posts. If you already have one with such knobs, the knobs should be unscrewed or sawed off flush with the headboard or footboard. Sand off splinters and sharp corners.
- Never use a crib that has loose or missing slats. Be sure that all slats are securely fastened in place and the space between slats is no more than 2-3/8 inches (60 mm) to avoid head entrapment/strangulation.
- If you paint or refinish baby furniture, use only high quality household lead-free enamel paint and let it dry thoroughly so there are no residual fumes. Check the label on the paint can to make sure the manufacturer does not recommend against using the paint on items such as baby items.
The following article is courtesy of the followingwebsite:
http://babyparenting.about.com/library/blhighchairsafe.htm
Special Offers
Resource Center
Submit your topic related site and we'll
review it for our Partner Sites where we
provide link exchange information.
Tour our site using the Site Map. We respect your privacy - see our terms for more info.